Skip to content
Step 1: Application
Form filling video guide
Watch a short video guide before you start filling out the form
Select your application area *
Selected “Other”? Describe your specific application area below *
Optional: Upload Any Additional Documents
Maximum file size: 25 MB
You may upload optional supporting files (jpg, png, pdf, doc, docx, xls, xlsx).
Step 2: Measurement Range & Calibration
Form filling video guide
Watch a short video guide before you start filling out the form
Measurement Task
Need more gases?
You can add any number of gases. If you have questions, please watch the video guide
Substitute Gas Calibration
You can add any number of gases. If you have questions, please watch the video guide
Step 3: Process
Form filling video guide
Watch a short video guide before you start filling out the form
Ambient temperature at the installation site
Dew point of the sample gas (if known)
Sample gas pressure
Note: The normal pressure specified here corresponds to the pressure at which the sensors are calibrated (calibration pressure). Calibration at the factory is possible for pressures up to a maximum of 10 bara. For pressures above 10 bara, calibration must be carried out by the customer (see operating instructions).
Sample gas temperature
Flow rate 
pipe cross-section, if applicable
Moisture Compensation
Enable if you need it. When the switch is green, compensation is active.
Pressure Compensation
Enable if you need it. When the switch is green, compensation is active.
Step 4: TCD3000 product selection
Form filling video guide
Watch a short video guide before you start filling out the form
TCD3000 SiA
Is the ATEX designation sufficient?
Yes – when the switch is enabled (green).
Sample gas connection
TCD3000 Si
Sample gas connection
TCD3000 Transmitter
Sample gas connection
Certificate 2.1
Enable if required (green = ON)
Certificate 3.1
Enable if required (green = ON)
Clean for Oxygen Service
Enable if required (green = ON)
Corrosion-resistant design
Enable if required (green = ON)
Additional Services:
Express Production
Enable if required (green = ON)
36-Month Warranty
Enable if required (green = ON)
Step 5: Contact Details
Form filling video guide
Watch a short video guide before you start filling out the form
Please select the appropriate option *
Please name the end customer *